Elumen8 Stage Par 90 Cold White, Руководство пользователя

Страница: 5 / 8

11-
2-light show
In slave mode, Master means the unit runs as the master unit, Slave1 or Slave 2 means
2-light show. In order to create a great light show, you can set Slave1 or Slave 2 on the
second unit to get contrast movement to each other, even if you have two units only.
4.2 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when is showing on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically one minute later. To go back to the
functions without any change press the MENU button again. If you use please refer to the
following diagram to address your DMX512 channel for the first 4 units.
2 channels
：
5. DMX512 Configuration
4-
y
Do not operate in dirty and dusty environment, also cleaning fixtures regularly.
y
Do not allow children to operate the fixture.
y
Do not touch any wire during operation as there might be a hazard of electric shock.
y
Avoid power wires together arounding other cables.
y
Disconnect the mains power before fuse/lamp replacement or servicing.
y
Replace fuse only with the same type.
y
In the event of serious operating problems, stop using the unit immediately.
y
Never turn on and off the unit time after time.
y
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
y
Do not open the unit as there are no user serviceable parts inside.
y
Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead
to damage or malfunction. Please contact the nearest authorized technical assistance
center.
y
Disconnect the mains power supply if the fixture is not being used for a long period of
time.
y
Always use the original packing when in transport.
y
Do not look directly at the LED light beam while the fixture is on.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit
is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a weight of 10
times of the unit’s weight. Also always use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out
of the touch of people and has nobody passing by or underneath it.