Elumen8 Beam 5RE, Руководство пользователя

Страница: 4 / 36

A 3A
—
The minimum distance between light output and the illuminated surface must be more than
12 meters.
—
Disconnect the mains power before fuse/lamp replacement or servicing.
—
Replace fuse/lamp only with the same type.
—
In the event of a serious operating problem, stop using the unit immediately.
—
The housing, lenses and the ultraviolet filter must be replaced if they are visibly damaged.
—
Do not open the fixture as there are no user serviceable parts inside.
—
Never try to repair the fixture by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance center if
needed.
—
Disconnect the mains power if the fixture is not being used for a long time.
—
Always use the original packing materials before transporting it again.
—
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
—
Hot lamp explosion hazard. Do not open the unit within 15 minutes after switching off.
—
Always replace the lamp if it is damaged, deformed or life-­‐expired.
—
Do not look directly at the light while the lamp is on.
—
Never touch lamp with bare fingers.
—
Do not operate the fixture without the lamp cover or when the housing is damaged.
Installation
:
1. Bolt each clamp (1) to the Omega holder with the bolt and lock nut through the hole in the
holder.
2. Fasten the omega holders (2) on to the bottom of the base by inserting quick-­‐lock fasteners (3)
into the holes of the base and tighten fully clockwise.
3. Hang the fixture to the support (4) through clamp and fasten the bolts (5). Fasten the safety
cable (6) through the bottom of the base and over the support.
4. The fixture uses the small Omega Clamp. Order code: CLAM21