www.prolight.co.uk
Alu HEX Par 64
User Manual
7
Master/slave mode
To set the master unit, press the
“MODE”
button on the rear of the master unit then select your
desired program. To set in slave mode, press the
“MODE”
button on the rear of the unit and set the
address to show
“SLAVE MODE”
on the LED display. The unit will now run in sequence with the master
unit.
Sound active mode:
To access the sound active mode, press the
“MODE”
button on the rear of the unit to show
“SOUND”
on the LED display. The unit will now be in sound active mode. Press
“ENTER”
the display will flash,
now use the
“UP”
and
“DOWN”
buttons to set the sound sensitivity level from
“SENS:00” - “SENS:31”
(00 = low, 31 = high).
Press the
“ENTER”
button to confirm any settings.
To exit out of any of the above options, press the
“MODE”
button.
Static colour mix mode:
To access the static colour mode, press the
“MODE”
button to show
“1.STATIC”
on the rear of the unit.
You can then use the enter button to select and set the desired colours and brightness for
R, G, B, W, A and UV from
“00” - “99”
. You can then set the strobe speed from
“F00” - “F99”
.
Press the
“ENTER”
button to confirm any settings.
To exit out of any of the above options, press the
“MODE”
button.
Built-in programs mode
To access the built-in programs mode, press the
“MODE”
button on the rear of the unit to show one of
the following on the display:
“2.CHANGE”
will show on the LED display for the 30 colours change mode.
“2.CHANG6”
will show on the LED display for the 6 colours change mode.
“04.DREAM”
will show on the LED display for the colour fade mode.
On the above 3 options you can then set the desired colour change speed from
“SP01” - “SP99”
and the
strobe speed from
“F00” - “F99”
.
Press the
“ENTER”
button to confirm any settings.
To exit out of any of the above options, press the
“MODE”
button.
