- 3 -
Basic Operation
Standby Mode
After connecting the power supply, the unit is in standby mode and the clock time 0:00 will
flash. Please refer to
“Clock and Alarm Time Setting” to set the time. Press the
POWER (1)
button to turn on the unit or press it again to go back to the standby mode.
Power On / Radio Mode
Press the
POWER (1)
button to switch on the unit, the current radio frequency appears on the
display for about 5 seconds, after which the current time indication returns to the display.
Clock and Alarm Time Setting
Clock Time Setting
In standby mode,
1.
Press and hold the
SET (9)
button until the hour and minute
digits flash.
2.
Press the
HR (6)
button to set the hours.
3.
Press the
MIN (7)
button to set the minutes.
4.
Press the
SET (9)
button again to confirm the clock time setting (hour
and minute digits will become solid when finished)
Alarm 1 Time Setting
In standby mode,
1.
Press and hold
AL1 (3)
button until the hour and minute digits flash.
2.
Press the
HR (6)
button to set the hours.
3.
Press the
MIN (7)
button to set the minutes.
4.
Press
AL1 (3)
button again to confirm the alarm 1 time setting (current time indication
returns to the display when finished).
Alarm 2 Time Setting
In standby mode,
1.
Press and hold
AL2 (4)
button until the hour and minute digits flash.
2.
Press the
HR (6)
button to set the hours.
3.
Press the
MIN (7)
button to set the minutes.
4.
Press
AL2 (4)
button again to confirm the alarm 2 time setting (current time indication
returns to the display when finished).
PLEASE NOTE:
When operating from batteries only (during back-up mode), the display will
be off and the clock will only remain accurate for a short period of time. The clock accuracy will
decrease due to the voltage drop of the backup batteries. It is important that the mains supply
is restored as soon as possible. If no backup battery is installed or the power interruption is
prolonged, you will need to set the clock again.
