Service menu
2280073 Rev.1
Page 32
Service menu
The service menu is used to make basic system settings at the MC1500. The structure of this
menu is set out below. To avoid mistakes, these settings are protected by a code which should
be given access only to properly trained persons.
The code for using the service menu is:
0109
:
Modification of parameters such as charging voltage, current limits, monitoring limits and
process times must be made appropriately. Inappropriate changes can influence functionality.
None of the settings can be changed unless the MC1500 is ready for use, i.e. unless it has
been switched on with control button 1 (On/Off). However, there should be no active charging
procedure and no battery connected to the output.
When button 3 (Enter) is pressed, a prompt appears on the LCD to enter a password. This
consists of four numeric characters and can be entered by using button 3 (Enter), button 4 (Up)
and button 5 (Down). Each of the four characters is selected using button 4 (Up) and button 5
(Down) and then confirmed with button 3 (Enter).
After correctly entering the password, you get to the MC1500’s service menu.
This menu is also navigated by using buttons 3, 4 and 5.
All of the setting options are described below:
