the state and then goes out.
Press the button (> 2 s).
Confirmation
telegrams are switched off.
The green
LED lights up for 1 second to indicate the
state and then goes out.
Every press of the button (> 2 s) switches
between settings.
Tap the button (< 1 s) to
switch to the
mode for switching the repeater on/
off.
The red LED flashes briefly once
every 2 seconds. Press the button (> 2 s).
The repeater is switched on. The red LED
lights up for 4 seconds to indicate the
state and then goes out.
Press the button (> 2 s). The repeater is
switched off. The red LED lights up for
1 second to indicate the state and then
goes out.
Every press of the button (> 2 s) switches
between settings.
Tap the button again (< 1 s) to switch to
normal mode. The two LEDs go out.
Checking the settings:
When you plug the actuator into the socket,
the green LED lights up for 2 seconds if
confirmation telegrams are active. If they
are not, the green LED only flashes briefly.
Finally, the red LED lights up for 2 seconds
if the repeater is active. If it is not, the
red LED only flashes briefly.
Semi-automatic motion detection
with
wireless motion detector (EEP A5-07-01):
Press the pushbutton to switch the device on.
This starts an off-delay time of 5 minutes.
If motion is detected within this time, the
device is switched back on. If no motion is
detected, the device switches off automati-
cally after 5 minutes. Finally, the actuator
reacts to motion for another 5 minutes and
if motion is detected, it switches back on
automatically. When this time expires, press
the pushbutton again to switch the device
back on. You can press the pushbutton at
any time to switch it off. No motion is then
evaluated.
Fully automatic motion detection with
wireless motion detector (EEP A5-07-01):
If the actuator is to switch on automatically
when motion is detected, e.g. in rooms without
daylight, replug the jumper to 'active' in the
sensor. If no motion is detected, the device
switches off automatically when the 5-minute
off-relay time expires. You can press the
pushbutton any time to switch the device on
or off. If motion is detected, the device
switches back on automatically.
If a
smoke detector FRWB
or a
heat alarm
FHMB
was taught in, the actuator switches
on immediately when it receives an alarm
telegram.
In the event of an alarm end telegram, the
contact does not open automatically.
Switch it off by pressing the pushbutton.
The socket must be easily
accessible.
Don’t insert in a row.
!
Frequency 868.3
MHz
Transmit power
max. 10 mW
Hereby, Eltako GmbH declares that the radio
equipment type FASSA-230V is in com-
pliance with Directive 2014/53/EU.
The full text of the EU declaration of
conformity is available at the following
internet address: eltako.com
Must be kept for later use!
Eltako GmbH
D-70736 Fellbach
Technical Support English:
+49 711 94350025
[email protected]
eltako.com
51/2020 Subject to change without notice.
