Tel
01384 275800
Fax
01384 275810
Website
eltafans.com
2
AC
VERSALINE VL
Installation Instructions
1.
WARNING
- This fan is fitted with a non self-resetting thermal cut-out which switches the fan off in the event of a fault condition. To reset,
turn the power off for one minute, then back on. Only a suitably qualified and competent person may carry out maintenance after the
electrical supply has been isolated.
CAUTION
-
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility.
WARNING
-
The appliance can only be used indoors.
2.0
General
2.1
It is important these Installation and Maintenance Instructions are fully adhered to.
2.2
Full details of the unit supplied are shown on the product nameplate. If in doubt about any detail contact Elta Fans or its agents
for clarification.
2.3
All electrical installation must be carried out by suitably qualified and competent personnel in accordance with all current statutory
requirements.
2.4
These instructions cover only the Elta Fans Ltd product and do not include the supply or installation of any safety equipment that may
be required e.g. adequate guarding or protection from rotating parts and proper electrical isolation.
2.5
Any declarations made by Elta Fans Ltd about product installation and safety, are dependent on the fan equipment being used within
installations which themselves meet the requirements of the relevant Standards and Directives of your region.
2.6
The fan is designed for use in up to 95% relative humidity. The fan is not suitable for corrosive or explosive atmospheres.
2.7
The installer should provide easy access to the fan to facilitate future maintenance.
2.8
The installer should ensure the fan is adequately supported.
2.9
The below statement is only applicable to the European market.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children without supervision.
2.10
The below statement is only applicable to the non-European market.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
2.11
Means for electrical disconnection must be incorporated in the wiring installation in accordance with the relevant wiring and electrical
regulations.
WARNING
-The fan must be isolated from the power supply during installation and maintenance. The fan must be earthed in accordance
with the local regulations. The appliance can only be used indoors.
3.0
3.1
Refer to the appropriate wiring diagram. Ensure that all earth connections are made.
3.2
The fan is to be installed so that the blades are more than 2.3m above the floor (for fans intended to be mounted at high level).
3.3
Precaution must be taken to locate the exhaust discharge terminal so as to avoid the backflow of gases into the room from the open
flue of gas or other fuel burning appliances.
Owner / installer:
The life of this apparatus and its efficiency will be increased if its use and maintenance is carried out in accordance
with these instructions and current statutory requirements. The installation and initial adjustments should be carried out by a
qualified and competent technician. Elta Fans Limited should be consulted before substituting or fitting parts from another
manufacturer. It is the responsibility of the installer to verify that the installation is in accordance with the following standards and the
owner is given the current User’s Manual.
Any modifications to the fan or its installation, even the smallest modification, change or elimination of security
components or pieces that influence the efficiency or loss of ventilation, will result in Elta Fans’ warranty
being cancelled.
4.
Installation
4.1
Upon receipt, the fan equipment should be visually inspected to check for any damage. Ensure that the impeller is free to rotate.
4.2
If there are any queries concerning the fan equipment, Elta Fans should be contacted prior to the installation.
4.3
Use the mounting bracket set supplied with the VL fan to fix the fan in the desired position to suit the application. The fan can be
mounted at any angle. If the fan is mounted with vertical outlet, a weather proof cover must be installed at the ducted outlet.
