GB-3
GB
F
NL
I
E
Wiring the RECEIVER
WARNING
Electric shocks can be fatal! Before working on
possible live components ensure the unit is discon-
nected from the power supply.
▷
For the electrical connection between the
RECEIVER and the receiving unit, polarity is
inconsequential.
▷
The RECEIVER is delivered with a prefabricated
connection cable. The RECEIVER may optionally
be delivered without a connection cable.
1
Wire the RECEIVER to the receiving unit.
▷
If a connection cable is already routed to the
receiving unit at the installation location, the pre-
fabricated connection cable on the RECEIVER
may be removed, as described below.
Removing the prefabricated connection cable
▷
Use the connection plug from the RECEIVER
for further wiring with the already routed con-
nection cable.
1
2
3
4
5
▷
Feed the new connection cable into the strain
relief facility, see figure
5
. Otherwise, the
RECEIVER cannot be closed.
Wiring completed
▷
Once wiring is completed, the RECEIVER re-
quires a charging time of < 5 min. During this
time, there is no communication with the other
units of the ACM WAVE SYSTEM.
▷
At the end of the charging time, the green LED
on the RECEIVER blinks every 10 s and the red
LED blinks at a rate of 1 Hertz.
▷
The charging time can be used for further in-
stallation work, see page 3 (Closing and
sealing the RECEIVER) and 3 (Installing the
gas meter).
Closing and sealing the RECEIVER
▷
Secure the RECEIVER against external access
with the seal.
1
2
3
Installing the gas meter
▷
For installing the gas meter in the pipework, refer
to the operating instructions for diaphragm me-
ters BK-G1.6 to BK-G25T, see www.docuthek.
com
Diaphragm meters BK-G1.6 to BK-G25T op-
erating instructions.
Attaching the TRANSMITTER
▷
The TRANSMITTER is connected to the Absolute
ENCODER AE2 index after the gas meter has
been installed in the pipework.
▷
The retaining screw and the calibration seal are
found at the rear of the TRANSMITTER housing.
1
2
3
▷
When connecting the TRANSMITTER to the
index, avoid bending the contacts.
6
4
5
▷
The red LED on the TRANSMITTER blinks.
▷
If the red LED does not blink, see page 5
(Assistance in the event of malfunction).
