In accordance with our policy of continual product improvement, we
reserve the right to amend the specification of these products without
prior notification.
© Elsy & Gibbons Limited 2004.
All rights reserved. No part of this manual may be reproduced by any
means without prior written consent.
Manual compiled and designed by Publications 2000. Tel 01670 356211
08/04/D64
Elsy & Gibbons,
Simonside
South Shields,
Tyne and Wear NE34 9PE
Telephone: 0191 427 0777
Facsimile: 0191 427 0888
www.elsonhotwater.co.uk
TO BE COMPLETED BY THE INSTALLER
1.
Product serial No. ...........................................................................................................
2.
Installation date ..............................................................................................................
3.
Name of Installer ............................................................................................................
Address ..........................................................................................................................
........................................................................................................................................
........................................................................................................................................
Telephone No. .................................................................................................................
4.
Type of controller fitted ...................................................................................................
5.
Details of supply tariff .....................................................................................................
6.
Is a scale reducer fitted?
Yes/No
Details .........................................................
7.
Is a Y type line strainer fitted?
Yes/No
Details .........................................................
10. ELSON CORAL E USER'S INSTRUCTIONS
1.
Your hot water system is designed to provide mains pressure hot water to all outlets including showers,
turning an ordinary shower unit into a 'Power Shower' without the need for expensive pumps.
2.
The temperature of the hot water supplied to your taps can be adjusted from 35° to 55°C by adjusting the
blending valve on the top of the unit. See section 5.2 on page 5. The temperature is factory set to approximately
50°C.
3.
The Coral E is designed to make the most of low price off-peak electricity, you should contact your electricity
supplier, asking for details of your particular supply and advice for economical use.
4.
For the most economical use of the Coral E you should restrict your main use of hot water (baths etc.) to such
a time that the water in the unit will be re-heated during the off-peak period.
5.
IMPORTANT: The 'Boost' immersion heater fitted to the Coral E operates on full price electricity, it should
therefore be used sparingly and always switched off after use. A runback timer should have been fitted when
the unit was installed.
6.
The Coral E is fitted with a safety overheat limit thermostat, see Fig. 2, which will automatically switch off the
'Overnight' immersion heater in the case of a control thermostat malfunction causing overheating. If you find
the tank is cold in the morning, press the reset button (use the end of a pen or pencil) on the limit thermostat
to reset it and the tank should be reheated overnight as normal. If you require hot water sooner, use the 'Boost'
immersion heater to heat the water (see note 5 above).
If the limit thermostat needs to be continually reset, contact your Installer.
7.
When running a bath, you can increase the temperature and volume of water by reducing the flow rate at the
tap, i.e. do not open it fully.
8.
When cleaning the Coral E do not use abrasive cleaners on the white metal cased models or wet cloths on the
hardboard cased models.
