3
Installation and commissioning
Leakage sensor Leak
• Version: 03.08.2017 • Errors and technical modifications subject to change without notice.
1.2.2. Probe
The product is compliant with the provisions of EC guidelines.
2.
Installation and commissioning
If the alarm output is used, the installation, testing, commissioning and
troubleshooting of the unit may only be performed by an electrician
(pursuant to VDE 0100).
2.1. Installation notes
DANGER!
Risk to life from live voltage (mains voltage)!
There are unprotected live components within the device.
•
VDE regulations and national regulations are to be followed.
•
Ensure that all lines to be assembled are free of voltage and take
precautions against accidental switching on.
•
Do not use the device if it is damaged.
•
Take the device or system out of service and secure it against
unintentional use, if it can be assumed, that risk-free operation is no
longer guaranteed.
The device is only to be used for its intended purpose. Any improper modification or
failure to follow the operating instructions voids any and all warranty and guarantee
claims.
After unpacking the device, check it immediately for possible mechanical damage. If it
has been damaged in transport, inform the supplier immediately.
The device may only be used as a fixed-site installation; that means only when assem-
bled and after conclusion of all installation and operational start-up tasks and only in
the surroundings designated for it.
Elsner Elektronik is not liable for any changes in norms and standards which may occur
after publication of these operating instructions.
Casing
Polished stainless steel
Installation
for placing on the floor
Protection category
IP 68
Electrode chemical resist-
ance
Water
Dimensions
Diameter: approx. 77 mm
Cable length
approx. 140 mm (plus cable grip and plugs)
Weight
approx. 200 g
