6
Installation and commissioning
Ventilation Unit WL610
• Date of issue: 25.05.2011 • Technical changes reserved. Errors reserved.
After unpacking the device, check immediately for any mechanical damages. In case of
transport damage, this must immediately notified to the supplier.
If damaged, the device must not be put into operation.
If an operation without risk may supposedly not be guaranteed, the device must be put
out of operation and be secured against accidental operation.
The device must only be operated as stationary system, i.e. only in a fitted state and
after completion of all installation and start-up works, and only in the environment in-
tended for this purpose.
Elsner Elektronik does not assume any liability for changes in standards after publica-
tion of this instruction manual.
2.2. Notes on wireless equipment
When planning facilities with devices that communicate via radio, adequate radio re-
ception must be guaranteed. The range of wireless control will be limited by legal reg-
ulation and structural circumstances. Avoid sources of interference and obstacles be-
tween receiver and transmitter, that could disturb the wireless communication. Those
would be for example:
•
Walls and ceilings (especially concrete).
•
Metal surfaces next to the wireless participants (e. g. aluminium construction
of a conservatory).
•
Other wireless devices and powerful local transmitters (e.g. wireless
headphones), which transmit on the same frequency (868,2 MHz). Please
maintain a minimum distance of 30 cm between wireless transmitters for that
reason.
2.3. Notes on mounting
The ventilator panel with the ventilator must be mounted such that the cover hood of
the air intake opening faces inwards.
The inner cover hood is fastened by locks on the ventilator panel. To remove the hood,
loosen the locks on both sides with a screwdriver. The electronic control of the venti-
lator is mounted under the cover hood.
When mounting and before first use, make sure the cover hood
is firmly fastened to the ventilator panel.
So that no water can penetrate through the air outlet on the outside when it is raining,
or due to other weather influences, the panel must be mounted such that the outlet fac-
es downwards.
