2
Description
Ventilation Unit WL610
• Date of issue: 25.05.2011 • Technical changes reserved. Errors reserved.
1.
Description
The
Ventilation Unit WL610
is installed in the roof ridge area of conservatories in-
stead of the normal glazing. The
WL610
can be operated in air extraction and recircu-
lation modes. The recirculation mode may be used for heat gain and reduction of water
condensation thanks to an integrated temperature sensor in the ventilation unit.
The
WL610
communicates wireless with the control systems WS1 Color, WS1000 Co-
lor and KNX WS1000 Color. The
Ventilation Unit WL610
may be operated directly
with the Remo 8 Remote Control.
Functions:
•
Air extraction mode
. Please pay attention to an adequate opening for supply
air of approx. 12 240 mm² per WL610 (e. g. two Supply Air Units WFL or equal
window opening)
•
Recirculation mode for heat gain
: Warm air from the ridge is spread in the
whole room
•
Recirculation mode for reduction of condensation water
: The controls
register critical conditions of temperature and dew point with the help of a
special calculation method and start the ventilation unit in the mayor of cases
even bevor humidity precipitates
•
Wireless control
without additional device, only the power supply has to be
connected
•
Quiet lateral blower
•
Highly
heat insulating housing
consists of integral skin foam
•
Extremely
tight closing flap
(spur gear, worm drive) with self-locking drive
and load limit switch
•
The
installation pane
l is powder-coated on both sides and has an extremely
high compressive strength
•
May be installed together with self-cleaning panes bacause of the silicon-free
manufacture
•
The power and radio electronics are built inside, yet not in the way of the air
current. Full maintenance from inside is possible
•
Manual operation with Remo 8 Remote Control possible (available separately)
1.0.1. Scope of delivery
•
Installation panel with ventilation unit and 10 m connection lead for voltage
supply
1.1. Technical specifications
Mains voltage
230 VAC, 50 Hz
Length connectiong lead
power supply
10 m
Power consumption
Maximum: approx. 40 VA
Standby:
approx. 2 VA
