elsner elektronik KNX AQS TH-B-UP, Установка и настройка

Страница: 49 / 56

48 Parameter setting
Sensor KNX AQS/TH-B-UP • as of software 3.1 • Version: 01.03.2017 • Technical changes and errors excepted.
AND logic output 3
AND logic output 3 inverted
AND logic output 4
AND logic output 4 inverted
AND logic output 5
AND logic output 5 inverted
AND logic output 6
AND logic output 6 inverted
AND logic output 7
AND logic output 7 inverted
AND logic output 8
AND logic output 8 inverted
5.13. Display settings
Values and text can be displayed over two or three lines in the display. These can be
internal readings or external data received from the bus. The input objects must be ac-
tivated in order to be able to select external data.
Two-line display: Line 1 upper case, Line 2 upper case
Three-line display: Line 1 lower case, Line 2 upper case, Line 3 lower case
You can switch from either display to the thermostat display by pressing any pushbut-
ton. Alternatively, the target value and/or temperature control can be permanently dis-
played.

Display and operation at the device , page 10
For manual temperature control , the parameter "Use thermostat display upon key
press" must be set to "Yes". In addition, you will need to set the pushbuttons which will
be used for temperature control.
The following further parameters will then appear:
Use object "display contrast" No • Yes
Display mode • two lines
(with optional thermostat display)
• three lines
(with optional thermostat display)
• Permanent thermostat