elsner elektronik 70550, Установка и настройка

Страница: 16 / 52

14 Parameter setting
Actuator KNX S1R-B4 compact • Version: 12.09.2022 • from application 1.0 • Technical changes and errors excepted.
5. Parameter setting
The default settings of the parameter are labelled by an underscore.
5.1. General settings
First set the general parameters for the bus communication (telegram rate,
transmission delay). Additionally, you can indicate if for the programming of scenes
all, or only the changed settings are applied to the bus.
Parameter „Application when programming“
If "all parameters" is selected, the values stored in the device (e.g. positions) are
overwritten by the ETS download in any case.
If "only changed parameters" is selected, only the parameters in the unit that have been
changed
in the ETS compared to the previous download will be overwritten.
In this way, for example, movement positions that were stored by the user with the
memory function via the bus are retained. If a value is changed via the bus (not in the
ETS!) then this value is retained with "only changed parameters".
5.2. Output
State here what is connected to the output channel.
Thereafter, the setting options will appear:
Settings for drives (channel A):
• General specifications for the connected drive
(see
Channel settings – drives , page 15)
• Control functions: Movement range limit, blocking, type of automatic
(see
Control (drives) , page 17)
• Automatic functions: Automatic can be specified externally or internally
(see
Movement limits , page 24 or Automatic for windows (drives) , page 31)
• Scenes: Movement positions (see Scenes (drives) , page 35)
Maximum telegram rate 1 • 2 • 5 • 10 • 20 telegrams per second
Send delay of switching and status
outputs after voltage returns 5 s … 2 h
For the use of scenes:
Application when programming all parameters • only changed parameters
Operating mode
Channel A controls • shutter
• blind
• awning
• window
• double switch function