elsner elektronik 70550, Установка и настройка

Страница: 37 / 52

35 Parameter setting
Actuator KNX S1R-B4 compact • Version: 12.09.2022 • from application 1.0 • Technical changes and errors excepted.
5.2.1.6.Scenes (drives)
A group address for scenes must be filed in the KNX system to control the scenes.
The input object ‘Channel X: call/save scenes’ of the actuator is linked to this group
address.
A scene is called , then the scene number is communicated to the actuator. The
movement position saved for this scene number in the actuator is then taken.
If the scene
saving function is used, then the current movement position is saved for
this scene number in the actuator.
The ‘Scenes’ menu item of the actuator is only shown if ‘Use scenes: yes’ was selected
in the settings for the drive channel. Every drive can
have up to 16 scene save
points for movement positions.
Activate a scene save point.
Assign a scene number to the scene save point. Use this scene number to call/save the
movement position stored in the actuator. Make sure that every scene number is used
only once per drive channel.
Set the movement position. If it is allowed to save scenes via the bus, this position only
applies after the ETS download until the first manual saving. Afterwards, the new
movement position saved in the actuator is used.
5.2.1.7.Button inputs (drives)
The inputs can be used as actuator button or bus button.
For connected drives the input 1 can be used alternatively for a zero position sensor.
Use scene save point X no • yes
Scene number 0...127
Shutter position in % or
Blind position in % or
Awning position in % or
Window position in % 0...100; 50
Slat position in %
(only for shutters)
0...100; 70
Operating mode
Use input 1 • no
• as a bus button
• as an actuator switch
• as a zero position sensor
Use input 2 (3 / 4) • no
• as a bus button
• as an actuator switch