elsner elektronik 70550, Установка и настройка

Страница: 17 / 52

15 Parameter setting
Actuator KNX S1R-B4 compact • Version: 12.09.2022 • from application 1.0 • Technical changes and errors excepted.
• Button inputs: Configuration as actuator button, bust button or for zero position
sensor (see
Button inputs (drives) , page 35)
Settings for switch functions
(Channel is divided into two switches A1|A2):
• General specifications for the switch function
(see
Channel settings – switch functions , page 44)
• Connecting different communication objects
(see
Connection (switch functions) , page 45)
• On/Off switch delays or time switching
(see
On/Off switch delays, time switching (switch functions) , page 45)
• Block function(see Blocking function (switch functions) , page 46)
• Button input: Configuration as actuator button or bus button
(see
Button input (switch functions) , page 46)
5.2.1. Channel settings – drives
If a drive is connected to the output channel, set first the general specifications for the
drive.
Driving direction:
Up/down, on/off or open/close can be exchanged.
Runtime:
The runtime between the end positions is the basis for moving into intermediate
positions (e.g. for movement range limits and scenes). Enter the runtime numerically
(in seconds).
If a dead time is observed while starting the curtain, then this can be entered manually
at this point or calculated automatically. Obey the manufacturer's instructions for the
curtain.
Exchange UP/DOWN (shutter, blinds)
Exchange RETRACT/EXTEND (awning)
Exchange OPEN/CLOSE (window)
no • yes
Runtime DOWN in sec (shutter, blinds)
Runtime EXTEND in sec (awning)
Runtime OPEN in sec (window)
1 … 320; 60
Runtime UP in sec (shutter, blinds)
Runtime RETRACT in sec (awning)
Runtime CLOSE in sec (window)
1 … 320; 65
Use dead times • no
• yes, enter by hand
during the position travel from closed
position in 10 ms
(only for manual input)
0 ... 600
for position movement from all other
positions in 10 ms
(only for manual input)
0 ... 600