elsner elektronik 70251, Установка и настройка

Страница: 18 / 22

16 ETS Database Parameters
KNX B4 Universal Interface • Version: 13.09.2021 • from application 1.0 • Technical changes and errors excepted.
6.2.4. Send value
Must be enabled if a value shall be written to the counter via KNX.
Interlock disabled • enabled
If Interlock is active, changes at the Input are not considered until the Interlock is deacti-
vated again.
Send value • on rising edge
• on both edges
• on short/long button press
• on long button press
Defines on which event(s) the object value is sent.
Contact type normally open • normally closed
Defines the contact type at the input, NO or NC. If NO is selected, the input is logic high
after the contact is closed.
Value type • Percent
• Angle
• Temperature
• 2-bit value (forced operation)
• 8-bit value
• 16-bit value
Sets the type of value.
Value rising edge Percent: 0 % …100 %
Angle: 0° • 5° • 10° …360°
Temperature (x 100/°C): -27300..32000; 0
2-bit: • ON, activate forced operation
• OFF, activate forced operation
• deactivate forced operation
8-bit: 0…255
16-bit: 0…65535
Sets value; available for "on rising edge" and "on both edges".
Value falling edge Percent: 0 % …100 %
Angle: 0° • 5° • 10° …360°
Temperature (x 100/°C): -27300..32000; 0
2-bit: • ON, activate forced operation
• OFF, activate forced operation
• deactivate forced operation
8-bit: 0…65535
16-bit: 0…65535
Sets value; available for "on both edges".