11
Addressing the equipment
Brightness and Wind Sensor KNX LW sl
• Status: 05.11.2014 • Errors excepted. Subject to technical changes.
2.6. After the auxiliary voltage has been applied,
the device will enter an initialisation phase
lasting a few seconds. During this phase no
information can be received via the bus.
3.
Addressing the equipment
The equipment is delivered ex works with the bus address 15.15.250. You program a
different address in the ETS by overwriting the address 15.15.250 or teach the device
using the programming button.
The programming button can be reached through the opening on the underside of the
housing; it is recessed by approx. 15 mm. Use a thin object to reach the key, e. g. a
1.5 mm² wire.
1 2
Fig. 17
1
Programming button for teaching the device
2
Programming LED (under the semi-transparent lid)
