elsner elektronik 70121, Установка и настройка

Страница: 23 / 26

21 Setting parameters
Temperature Sensor KNX T-AP • Version: 27.01.2020 • Errors excepted. Subject to technical changes.
Frost/heat protection
Set the setpoint for heating (frost protection) and/or cooling (heat protection) and ad-
just the activation delay. The delay allows you to leave the building before the controls
switch to frost/heat protection mode.
6.6. Logic
The device provides 8 communication objects for logic inputs, four AND and four OR
logic gates.
Activate the communication objects of the logic inputs.
Activate the required logic outputs.
AND logic
OR logic
6.6.1. AND logic 1-4 and OR logic outputs 1-4
The same setting options are available for AND and OR logic.
Each logic output may transmit one 1-bit or two 8-bit objects. Determine what the out
put should send if logic = 1 and = 0.
Use frost/heat protection No • Yes
Setpoint heating in 0.1°C
(if the heating regulator is being used)
-300 … 800
Activation delay
(after opening windows) none • 1 s … 2 h
Setpoint cooling in 0.1°C
(if the cooling regulator is being used)
-300 … 800
Activation delay
(after opening windows) none • 1 s … 2 h
Window status before first call Closed • Open
Logici input communication objects do not release • release
AND logic 1 not active • active
AND logic ... not active • active
AND logic 4 not active • active
OR logic 1 not active • active
OR logic ... not active • active
OR logic 4 not active • active