elsner elektronik 3090, Установка и настройка

Страница: 12 / 40

10 Installation and commissioning
Weather Station Suntracer KNX-GPS light • Version: 30.09.2020 • Technical changes reserved. Errors reserved.
2.1.5. Weather station layout
2.1.6. Connection of the weather station
The weather station cover with the rain sensor snaps in on the left and right along the
bottom edge (see Fig.). Remove the weather station cover. Proceed carefully, so as not
to pull off the wire connecting the PCB in the bottom part with the rain sensor in the
cover (soldered cable connection in case of 230 V AC version, cable with plug in case
of 20...32 V DC version).
Push the power supply and bus connection cable through the rubber seal on the bot-
tom of the weather station and connect voltage and bus +/- to the provided clamps.
For 20...32 V DC devices the connection cable must be plugged in between the cover
and circuit board.
Fig. 11
1
Screw-on cover (230V device)
2 Cover
3 Cover snaps
4 Bottom part of housing
5 Temperature sensor
6 Wind sensor
7 Brightness sensor
8 Rain sensor
3
4
Unsnap cover
and remove upwards
2
1
5
6
7
8
Fig. 12
Remove the cable shielding under the circuit
board and only feed the connector cables up-
wards through the openings in the circuit
board.