Elotech R 1120, Руководство по описанию и эксплуатации

Страница: 2 / 16

1. Contents
1. Contents............................................................................................................................2
2. Installation Instructions.....................................................................................................2
3. Type Code.........................................................................................................................3
4. Connection Diagram..........................................................................................................3
5. Display and Keyboard........................................................................................................4
6. Operating Levels...............................................................................................................5
7. Configuration Level............................................................................................................6
8. Parameter Level................................................................................................................10
9. Operating Level.................................................................................................................13
10. Basic Level........................................................................................................................14
11. Technical Data..................................................................................................................15
12. Error displays.....................................................................................................................16
2. Installation Instructions
Make sure that the device is used for the intended purpose only.
This controller is designed for installation in control panels.
Protect the device against impermissible humidity and contamination.
Ambient temperature must not exceed 50 °C (122 °F).
Electrical connections must be made according to valid regulations and by properly qualified personnel.
If using thermocouple sensors, compensation lines have to be connected directly to the controller terminals.
Sensors may be connected only in compliance with the programmed range.
Sensor cables and signal lines (e.g. logic or linear voltage outputs) must be laid separately from control lines
and mains voltage supply cables (power cables).
It is not permitted to connect the grounds of the sensor-inputs and logic-outputs with each other.
Separate installation of controller and inductive loads is recommended.
Interference from contactor coils must be suppressed by connecting adapted RC-combinations parallel to the
coils.
Control circuits (e.g. for contactors) should not be connected to the mains power supply terminals of the
controller.
The configuration parameters are generally to be selected first.
Disclaimer of Liability
We have checked the contents of this document for conformity with the hardware and software described.
Nevertheless, we are unable to preclude the possibility of deviations so that we are unable to assume
warranty for full compliance. However, the information given in the publication is reviewed regularly.
Necessary amendments are incorporated in the following editions.
We would be pleased to receive any improvement suggestions which you may have.
The information contained herein is subject to change without notice.
Electronic scrap and components are subject to special treatment and must be disposed of by authorized
companies.
Manual R1120-X0-00-X_EN Release: 1.04 © Elotech GmbH Page 2/16