Elon 117014, Инструкции по применению, Страница: 43 / 48

43
© 2021, Elon Group AB. All rights reserved.
REMOVING THE COLLECTED WATER
There are two ways to remove collected
water.
• 1 — Use the bucket
• When the unit is off and if the bucket is full, the unit will beep
8 times (on some models) and the Water Full indicator light
will flash.
• (For some models) When the unit is on and if the bucket is
full, the compressor turns off and the fan turns off after 30
seconds, then the unit will beep 8 times and the Water Full
indicator light will flash.
• Slowly pull out the bucket. Grip the left and right handles
securely , and carefully pull the bucket straight out so water
does not spill. Do not put the bucket on the floor because the
bottom of the bucket is uneven. Otherwise the bucket will fall
and cause the water to spill.
• Empty the water and replace the bucket. The bucket must be
in place and securely seated for the dehumidifier to operate.
• The machine will re-start when the bucket is restored to its
correct position.
1 — Pull out the bucket a little.
2 — Hold both sides of the bucket, and pull it straight out of
the unit.
3 — Pour the water out.
NOTE
• When you remove the bucket, do not touch any parts inside the unit. Doing so may damage the product.
• Be sure to push the bucket gently all the way into the unit. Banging the bucket against anything or failing to push it in securely may
prevent the unit from operating correctly.
• When you remove the bucket, if there is any water inside the unit you must dry it.
2 — Continuous draining
• Water can be automatically emptied into a floor drain by
connecting a water hose to the unit (not included).
• Remove the rubber plug or cut the cover down from the rear
drain hose outlet. Attach a drain hose and lead it to the floor
drain or a suitable drainage facility.
Remove the
rubber plug
Attach the hose to the
drain hose outlet
• Make sure the hose is secure so there are no leaks.
• Run the hose toward the drain, making sure that there are no
kinks that will stop the water flowing.
• Place the end of the hose into the drain and make sure the end
of the hose is level or sloping downwards to let the water flow
smoothly. Do not let the hose run upwards.
• Make sure the water hose is lower than the drain hose.
• Select the desired humidity setting and fan speed
• on the unit for continuous draining to start.
NOTE:
When the continuous drain feature is not being used, remove
the drain hose from the outlet and reinstall the rubber plug.