Eloma ELH 10-1, Инструкция по установке и эксплуатации, Страница: 11 / 24

9
2.5 Option : Core temperature control
The core temperature control serves for exact control of the product center temperature.
Such control being especially important for large joints.
The advantage : Thanks to this function it is possible to pre-select the desired product center
temperature, thus determining the end of the roasting process.
The core temperature probe is fixed in a clip on the left-hand side inside the oven cavity.
Once the desired product core temperature is reached, there is a sound signal and the oven switches
off automatically..
How to operate the core temperature control ?
Display : Actual temperature
Display : Nominal temperature
Use setting keys to enter nominal
temperature
Sound signal: Decide ON – OFF
Start core temperature control
Decide on function core temperature
control ON / OFF
Red LED's in the two display fields indicate stand-by, once the unit is
connected.
Punch the probe into the middle of the product, close the door.
Push ON / OFF key to activate core temperature control. right display
indicates actual core temperature.
Use the setting keys to enter the nominal core temperature. The nominal
core temperature has to be set at least 1 ° C ( 34° F) higher than the
displayed actual core temperature , otherwise the control does not respond.
Press this key if a sound signal is desired as soon as the product is ready,
red LED is lit.
Now turn selector switch to position 2 or 3 (hot air operation with or without
illumination), set the time to continuous operation =

and set the desired
temperature for the oven cavity.
Press this key to start a program with core temperature control, LED is lit.
Once the selected nominal core temperature is reached, automatic switch off
and sound signal – if set, the pilot lamp extinguishes.
Press this key to stop the buzzer.
Press key ON / OFF to switch off core temperature control function.
In case a trouble occurs on the display, just press START key and the
unit is again ready for service, if not, see point 5.1