User Manual: Elo
®
Tablet
SW602113 Rev B, Page 54 of 59
compliance to this equipment would void the user’s authority to operate this device.
Canada Compliance Statement:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Notice to Users in Canada:
This equipment complies with the Class B limits for radio noise emissions from digital apparatus
as established by the Radio Interference Regulations of Industrial Canada.
Notice to Users in the European Union:
Use only the provided power cords and interconnecting cabling provided with the equipment.
Substitution of provided cords and cabling may compromise electrical safety or CE Mark
Certification for emissions or immunity as required by the following standards:
This Information Technology Equipment (ITE) is required to have a CE Mark on the
Manufacturers label which means that the equipment has been tested to the following
Directives and Standards: This equipment has been tested to the requirements for the CE Mark
as required by EMC Directive 2004/108/EC as indicated in European Standard EN 55022 Class
B and the Low Voltage Directive 2006/95/EC as indicated in European Standard EN 60950.
General Information to all Users:
This equipment generates, uses, and can radiate radio frequency energy. If not installed and
used according to this manual the equipment may cause interference with radio and television
communications. There is, however, no guarantee that interference will not occur in any
particular installation due to site-specific factors.
1. In order to meet emission and immunity requirements, the user must observe the following:
a. Use only the provided I/O cables to connect this digital device with any computer.
b. To ensure compliance, use only the provided manufacturers approved line cord.
c. The user is cautioned that changes or modifications to the equipment not expressly
