Combined Storage Heaters
4
3.- Take off the front panel by removing the two screws at the bottom of the heater.
4.- Set the heater in the selected installation area and mark the fixing points on the wall using a pencil.
Use the heater fixing holes as a template and mark the wall through the fixing holes. Drill the required holes into
the wall.
Fix the heater to the wall.
Please note the weight of the heater is taken by the feet, the wall fixing screws are only to prevent the heater
overturning. If there is any doubt as to the strength of the wall please consult an expert. Storage heaters are very
heavy and the installer must ensure that they are securely fixed and that there is no possibility of them
overturning.
5.- Connect the heater using the enclosed wiring diagram. Ensure that all connections are firm
.
The “restricted supply” leads must be connected to a supply controlled by means of a programmer.
The “unrestricted supply” leads must be connected to a 24 hours supply. Use silicone covered wire.
Do not leave any remaining wire inside the heater. Do not connect the convector element yet.
6.- Remove the inner front panel with the attached convector element.
Warning. At the other side of this front panel there is a breakable thermal insulation panel. Both sides
must be handle with care. Avoid touching the insulation and the convector element.
7.- Do not disconnect the electrical elements. Remove the packaging then lift and recline the elements.
8.- Place the storage bricks carefully, with the flat side facing the back of the heater. Arrange two rows of bricks
(fig 3).
Fig.2
Fig.3