Elna International Corps. SA
Xquist
service manual
FRONT PANEL CONNECTION
1. Remove the connectors 4, 5, and 6 connected
from the front panel to the microcomputer
circuit board.
2. Then draw out the flexible card connector 7
after the lock of connector 6 has been
released.
3. Remove connector 8 connected to the inverter
circuit board.
To remove the Rear panel.
1. Remove the Under cover.
2. Remove the Belt cover.
3. Remove the Free arm bottom cover.
4. Loose the 5 screws from the bottom plate
base.
5. Disconnect all Front panel connectors.
REAR PANEL
1. Loose the screw 1.
2. Remove the screw 2,
situation of this screw
.
Turn the hand wheel so that the needle bar is
in lowest positioning (this screw fixe the rear
cover and is to reach from the front inside over
the take up lever).
