27
BH sensor
1.6 mm gap
TO ENTER ADJUSTING MODE:
MECHANICAL ADJUSTMENT
ADJUSTING BUTTONHOLE LEVER POSITION
TO ADJUST THE BUTTONHOLE LEVER GUIDE:
1. Enter the buttonhole sensor adjusting mode. (see below. The LCD should display BH symbol.)
2. Remove the face cover (see page 4) and loosen the setscrew (A).
3. Move the buttonhole lever guide so the BH symbol disappear when the button hole lever is lowered.
Tighten the setscrew (A).
TO ADJUST THE BUTTONHOLE SENSOR POSITION.
4. Attach the buttonhole foot (R).
5. Lower the buttonhole lever to its lowest position and open a 1.6 mm gap between the slider and the
buttonhole foot.
6. Turn the adjusting screw to the left until the LCD display BH symbol.
7. Next, turn the adjusting screw to the right until the BH symbol disappears.
8. Turn off the power switch.
9. Attach the face cover.
NOTE: If there is any lint or dust in the buttonhole sensor slit, loosen the 2 setscrews (B) and
clean it out with a swab.
Turn the power switch ON while pressing the
needle up/down button and locking stitch button
simultaneously.
Press the start/stop button to
select the step “SC 03”.
Setscrew (A)
Buttonhole lever guide
Buttonhole lever
Buttonhole foot (R)
Adjusting screw
Setscrew (B)
Setscrew (B)
