44
(2) How to make the adjustment screen appear and how to complete the procedure
(2) -1 Positioning the panel switch
1. From the state that the power to the machine is turned OFF, pressing start/stop switch, reverse
stitching switch and thread trimming switch, turn ON the power switch.
2. Panel switch positioning screen is displayed.
3. Press the red point located at the bottom of the left side, and the point changes to the bottom of the
right side. Every time the red point is pressed, the red point changes from the top of the left side to
the top of the right side in order.
4. The service mode screen is displayed at the time when the point at the top of the right side is
pressed.
5. Press “Save” key and “Pictograph .....” is displayed.
Never turn OFF the power to the machine while this message is being displayed. (Setting will be
broken.)
6. When the message of “Pictograph” is displayed, turn OFF the power to complete the procedure.
7. Perform turning the power ON/OFF again under the main body mode. (In the state that the
embroidering device is removed)
(2) - 2 Service mode
1. From the state that the power to the machine is turned OFF, pressing reverse stitching switch and
thread trimming switch, turn ON the power switch.
2. Service mode screen is displsayed and press the corresponding switch.
3. Completing procedure is the same as that of the aforementioned positioning panel switch.
When “Save” key is pressed at the service mode setting screen, the data is stored in memory and
not stored in memory with “End” key.
<Service mode screen>
