40
HOW TO USE THE GATHERING ATTACHMENT
1. To install the gathering attachment. (Fig.1)
1) Open the side cover.
2) Loosen the attaching screw, and slide the gathering
attachment onto the machine from right to left. (You will
have to rotate the arm toward you in order to do this.)
Tighten the attaching screw.
3) Loosen the thumb screw and raise the until you can
rotate it onto the needle plate. Set the bottom of the arm
to the height of the raised feed dog and tighten the thumb
screw.
NOTE: When the gathering attachment is installed, the looper
cover cannot be opened. To open the looper cover,
remove the attachment.
3. Gathering:Place 2 pieces of fabric right side together (fig. 2).
The fabric on the bottom will be gathering.
For best results, do a trial sewing. Make sure the bottom
piece is shortened in half by gathering.
(Results will differ depending on the type of fabric and
differential feed ratio.)
1) Set the differential feed dial to 1 and sew the two
pieces (right sides together). Rotate the arm out from
between the fabric. Then slowly sew 2 or 3 stitches.
2) Turn the hand wheel until the needle pierces the
fabric. Raise the presser foot.
3) Set the differential feed dial to 1.5 ~ 2.25.Insert the
arm between the two piece of fabric, then lower the
presser foot and sew again.
4) Sew, guiding the two pieces of fabric with your hands
(Fig. 3).
NOTE: If you want to stop gathering and continue with
normal sewing, stop sewing and drop the needle
into the fabric by turning the balance wheel. Pull
the arm toward you.
Set the differential feed dial to 1 and continue
sewing.
* the grooves on the arm act as an extension of the
scale.
Side cover
Attaching screw
Thumb screw
To atacch, slide to
onto the setscrew
Fig.1
Right side
of fabric
Right side
of fabric
Fig.2
Fig.3
APPENDIX
1
2
3
4
1 Arm
2 Attaching plate
3 Thumb screw
4 Groove
2. Machine setting : Set the thread tension as you would for
ordinary serging (2-needle 4-thread serger).
1) Thread tensions:
Around 3
2) Stitch length dial:
3~4
3) Differential feed dial:
1.5~2.25
4) Presser foot:
STD.
5) Upper knife:
Use
6) Chaining finger:
STD.
7) Lower looper
pretension setting slider:
*STD.
8) Changeable thread guide: *3/4threads
*Applies only to machine with this function.
Содержание 792D
