F
The impedance of the loudspeaker connected here must not fall below 4
.
This is the
RIGHT/MONO MAIN
loudspeaker output of your PMF600 . Where you
can connect the right loudspeaker of a stereo system . For this purpose , switch must
be set to its upper position . If however , you run a mono main mix (switch set to its
lower position ) , this loudspeaker output provides the main mix signal in mono .
36
21
21
The
BRIDGE
loudspeaker output allows you to combine the left and right stereo
channel in one mono output , which is useful for applications that require the use of
one loudspeaker only . To use the BRIDGE output , switch must be set to
LEFT/RIGHT
.
37
21
F
Always connect the BRIDGE jack to a loudspeaker with a minimum impedance
of 8
!
F
Please note that the power delivered to the speaker connected to the BRIDGE
output is considerably higher than the power provided to the speakers wired
to the parallel speaker outputs . Please read the information given on the rear
panel of your PMF600 .
F
When using the BRIDGE loudspeaker output , NEVER use any of the other two
connectors ( RIGHT/MONO MAIN and LEFT/MONITOR ) at the same time !
This is the
LEFT/MONITOR
loudspeaker output of your PMF600 , to which you can
connect the left loudspeaker of a stereo system ( switch set to its upper position).
If you do a main mix in mono ( switch set to its position ) , this loudspeaker
output provides the monitor signal in mono .
38
21
21
F
The impedance of the loudspeaker connected here must not fall below 4
.
F
Information on how to properly connect your speaker with regard to polarity can
be found on the rear of the unit ( PIN assignment ) .
BRIDGE/STEREO Switch : Mode option when the switch is on BRIDGE,
the mixes is on
“
BRIDGE
”
working mode, when in STEREO it is on
“
STEREO
”
working mode.
39
3. EFFECTS PROCESSOR
A special feature of your PMF600 is its built-in multi-effects processor . The processor
comes with 99 different standard effects such as reverb , chorus , flanger , delay , vocal
distortion as well as various effects combinations .
FX
REVERB
REVERB
Cathedral
: Simulates the dense , long reverberation of a large cathedral , which is
appropriate for solo instruments or vocals in slow pieces . Please choose between two
variations .
