The
TAPE/LINE IN
RCA input of channel 10 allows you to feed in external stereo
signals from your CD player or tape deck , for example .
12
The
TAPE / LINE OUT
RCA output provides the stereo main mix signal of your
PMF600 and can be routed to , say , a recording machine .
13
F
When the TAPE OUT signal is connected to a tape deck whose output signal is
routed back to the TAPE IN on the PMF600 feedback can be produced as soon as
you start recording . Be sure to interrupt the connection to the TAPE IN before
recording !
The phantom power supply provides the voltage necessary for the operation of
condenser microphones . Use the
PHANTOM POWER
switch to activate the supply
together for channels 1 - 9 (XLR connector) . The LED above the switch is lit when
phantom power is on .
14
This is the PMF600 graphic stereo equalizer which comprises two units and can be used
to adapt the sound to the room acoustics .
15
The stereo equalizer is effective on the main mix when both units have been activated
with the EQ IN buttons and the MODE switch is set to its upper position
(
LEFT/RIGHT
) .
16
21
The stereo equalizer use one unit each to process the main and monitor mix
signals if both units are on and the MODE switch is set to its lower position
( MON/MAIN
).
21
Use the
EQ IN
buttons to switch the two equalizer units on or off .
16
Press the
RUMBLE FILTER
button to activate the low -cut filter of channels 1-6 . This
filter eliminates unpleasant bass frequencies (e.g. Microphone pop noise)
17
The
FX TO MON IN
control determines the effects intensity of the multi - effects
processor as part of the monitor mix . Tum the control fully counter-clockwise to add
no effect to the monitor mix .
18
The
MONITOR LEVEL
control adjusts the volume of the monitor mix .
19
Use the
MONITOR LEVEL
display to control the monitor signal level . The upper
LED (LIM) lights up when the built-in limiter is activated , thus protecting against
overload .
20
With this
MODE
switch you can determine whether the PMF600 works as a stereo
amplifier (
LEFT/RIGHT
) or as a dual mono amplifier(
MON/MAIN
) . Please
note that the equalizer function also depends on this switch setting (see ) .
21
15
The
FX TO MAIN
control functions as FX return for the built-in effects processor
Use this control to add the desired effect signal to the main mix . No effect signal is
added when the FX TO MAIN is set fully counter-clockwise .
22
The
MAIN LEVEL
control governs the overall volume of the PMF600 .
23
The
MAIN LEVEL
display reads the output level of the PMF600 . The upper LED(LIM)
lights up when the built-in limiter is activated , thus protecting against signal peaks .
24
Use the
FX FOOT SWITCH
jack to connect any commercially available foot controller
It allows you to bypass the effects unit .
25