12
Condensation
Condensation is the formation of small drops of water on the inside or outside of
this product, especially on the inside surface of the lens, when moisture in the air
changes to liquid when it is brought from a cold place suddenly into a warm place.
This is not a malfunction.
Using this product with condensation may result in malfunction. If condensation
occurs, turn off the power, swipe the surface with a dry soft cloth, and then leave
this product in the place where humidity and dust are less and temperature is
stable (between 10° and 30° C). Start to use again after condensation is
completely gone. If this product is used with the condensation left on the inside of
the camera lens, the product may not record clear images.
Built-in microphone
Operational sounds from this product itself may be recorded when the built-in
microphone is used; however, that is not a malfunction of this product.
Precautions for shooting
The recording time varies depends on the resolution and the recording quality.
Do not use this product in places where photo or video recording is prohibited by
law. Doing so may cause you to be ordered to leave, subjected to fine, be arrested,
and/or forfeit the product.
Do not use this product for purposes prohibited by law. Doing so may cause you to
be subjected to fine, be arrested, and/or forfeit the product.
Normal maintenance
Do not clean this product with strong solvents, such as thinner and benzene. Doing
so may cause malfunction.
Wipe with a dry soft cloth. When this product is splashed with detergent, soap, hot
spring, bath additive, sun oil, sun screen, etc., wipe it off with a dry cloth
immediately.
Luminescent spot and black spot
This product uses a CMOS area image sensor composed of numerous pixels, and
some of the pixels may not operate normally. Therefore, luminescent spots or black
spots could be witnessed on the output screen. This is not a defect but a
phenomenon peculiar to a CMOS area image sensor.
