Ellipse ECV137W, Инструкция по эксплуатации

Страница: 21 / 22

5.TROUBLESHOOTING
You can solve many common freezer problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the Service Center.
PROBLEM POSSIBLE CAUSE
Freezer does not operate.

Not plugged in.

The circuit breaker tripped or a blown fuse.

The freezer temperature control is set at "0/OFF".
Compressor turns on and off frequently.

The room temperature is hotter than normal.

A large amount of food has been added to the
freezer.

The door is opened too often.

The door is not closed completely.

The temperature control is not set correctly.

The door gasket does not seal properly.

The freezer does not have the correct clearances.

The freezer has recently been disconnected for a
period of time. Four hours are required for the
freezer to cool down completely.
Temperature inside the freezer is too warm.

Temperature control is set too warm. Turn the control
to a cooler setting and allow several hours for the
temperature to stabilize.

Door is kept open too long or is opened too
frequently. Warm air enters the freezer every time
the door is opened. Open the door less often.

The door is not closed completely.

The door gasket does not seal properly.

A large amount of warm or hot food might have been
stored recently. Wait until the freezer has had a
chance to reach its selected temperature.

The freezer has recently been disconnected for a
period of time. Four hours are required for the
freezer to cool down completely.
Temperature inside the freezer is too cold.

Temperature control is set too cold. Turn the control
to a warmer setting and allow several hours for the
temperature to stabilize.
Popping or cracking sound when compressor
comes on.

Metal parts undergo expansion and contraction, as in
hot water pipes. This is normal. Sound will level off
or disappear as freezer continues to run.
Bubbling or gurgling sound, like water boiling.

Refrigerant (used to cool freezer) is circulating
throughout the system. This is normal.
Code E2

Freezer temperature sensor failure
Code E5

Freezer defrosting sensor failure.
Code E6

Communication failure
Code E7

Ambient temperature sensor failure
Code E9

Freezer high temperature.
If after consulting the troubleshooting guide your problem is still not resolved, please contact the
Corbeil Electrique Inc .branch where your purchase was made
.
21