page 5
7. Motor Housing Assembly.
Temporarily
swing motor housing up to
hanging bracket to determine which
2 screws in hanging bracket align with
slotted holes on top rim of motor
housing.
Partially loosen
the 2 screws in
the hanging bracket that correspond to
slotted
holes in the motor housing.
Remove
the
other
2 screws from the
hanging bracket.
Remove motor housing from j-hook on
hanging bracket. Align slotted holes in
motor housing with loosened screws in
hanging bracket. Twist motor housing to
lock. Carefully push wiring and wire
connectors into outlet box. Re-insert the
2 screws that were previously removed
and then tighten all screws to secure
motor housing.
Locate housing ring. Align slots inside
housing ring with posts at top of motor
housing. Twist housing ring to lock.
motor
housing
hanging bracket
8. Blade Assembly.
Time Saver
: Washers for blade
attachment screws can be set on each
screw prior to installing blades.
Locate 12 blade attachment screws
and washers in hardware pack. Slide a
blade through one of the narrow,
rectangular openings on the motor
housing, aligning holes in blade with
holes in blade arm, which is
pre-attached to the
underside
of the
motor housing and located
inside
the
motor housing--
refer to drawing at
right
. Insert 3 blade attachment screws
(along with washers) with fingers first
and then tighten screws securely with
a Phillips screwdriver. Repeat
procedure for each remaining blade.
Note
: Tighten blade attachment screws
twice a year.
blade
(
view from
underside
)
blade attachment
screws and washers
blade
arm
j-hook
slotted hole
housing
ring
post
motor
housing
screws
motor housing
motor
housing
screws
slot
