HP201 / HP202L / HP202LG
3/8
2.00 Installation
1) Disconnect siren module speaker wires. Remove the
speaker from the housing by loosening the fastening
screw and releasing the support (see figure 2).
2) Fasten the bottom of the siren to the wall using the bolts
and holes provided (see figure 1).
3) Insert the speaker module by fastening it to the support
and securing it with the specific screw.
4) Connect the terminal board (see section 3.00) and the
flasher. Connect the two anti-opening/anti-removal limit
switch wires to the siren module tamper terminals. Pro-
gram the siren (see section 4).
5) Remove the adhesive tape (A) holding the anti-opening/
anti-removal limit switch and lift it . The screw on which the
limit switch rests is calibrated by the manufacturer to close
the contact when the cover is fitted.
hole for fastening
to wall
external cover
fastening screw
hole
wire hole
hole for fastening
to wall
anti-removal
and anti-opening
limit switch
wire hole
internal cage
fastening screw
hole
internal cage
fastening screw
hole
external cover
fastening screw
hole
hole for fastening
to wall
12V 1.9Ah
battery
compartment
internal cage
fastening screw
hole
internal cage
fastening screw
hole
fig.1
fig.2
external cover
fastening screw
hole
hole for fastening
to wall
