15
3.7. SMS Keyword
When you send a SMS command to the
Control Panel, the correct SMS Keyword must
be entered in the SMS message for the Control
Panel to recognize the command.
1. Select SMS Keyword, you will be asked if
you want to change SMS Keyword, press
“OK” to confirm.
2. Enter the new SMS Keyword, press “OK” to
confirm.
<
<
N
N
O
O
T
T
E
E
>
>
Default SMS Keyword is “PROG”
SMS Keyword is case sensitive
3.8. Reset GSM
Reset GSM function allows you to reset your
GSM module.
1. When you select the function, the screen will
display “Please wait”. Do not touch the
Control Panel during the GSM reset
process
2. When GSM reset is complete, the screen
will return to Programming Mode.
4. Operation
4.1. Away Arm
Arming the System
1. When the system is in Disarmed Mode
(Alarm off), press the arm key on the Control
Panel, Remote Controller, Remote Keypad,
or send an SMS arm command with your cell
phone.
2.
The Exit Delay Timer will be displayed and
begin to count down. During the Exit Delay
period, the exit sound will play, unless it has
been switched off.
3. When the Exit Delay time is up, the Control
Panel will sound a long beep. Alarm On will
be displayed on the screen and the system
enters Away Arm Mode.
Stopping the Exit Delay
1. Press the disarm key on Control Panel and
enter the PIN Code, press the disarm key on
Remote Controller, or enter the PIN code
and press the disarm key on Remote
Keypad. You can also send an SMS disarm
command with your cell phone.
2. The Exit Delay Timer will stop, and the
system will return to Disarmed Mode. (Alarm
Off)
Extend the Exit Delay
The Exit Delay time can be extended by
pressing the Arm key on the Remote
Controller, or entering the PIN Code and
pressing Arm key on the Remote Keypad. The
Exit Delay timer will be reset and start counting
from the beginning.
4.2. Home Arm
Home Arm the System
1. When the system is in Disarmed Mode
(Alarm off), press the arm keyon the Control
Panel, Remote Controller, Remote Keypad,
or send an SMS arm command with your cell
phone.
2.
The Exit Delay Timer will be displayed and
begin to count down. During the Exit Delay
period, the exit sound will play, unless it has
been switched off.
3. When the Exit Delay time is up, the Control
Panel will sound three short beeps. Home
will be displayed on the screen and the
system enters Home Arm Mode.
Stopping the Exit Delay
The Exit Delay can be stopped following the
steps described in Stopping the Exit Delay in
Away Arm.
Extend the Exit Delay
The Exit Delay can be extended following the
steps described in Extend the Exit Delay in
Away Arm.
4.3. Force Arm
When you arm the system, if any fault event
exists in the system, the Control Panel will
sound a ding-done warning sound to indicate
arming is prohibited, the fault event will be
displayed on screen
At this moment, you can first rectify all of the
problems and then clear the Fault Display and
you will be able to arm the system normally.
If you want to Arm/Home Arm the system with
the fault situation persisting following the steps
below to Forced Arm.
1. Press ARM / HOME button again, you will
