ELKO - SmartDim Multiwire Universal LED Push
Resetting the device
You can reset the device to factory default manually.
To reset the device:
Short press push button 3 times (< 0.5 s) and then long press the push button
once (>10 s). after 10 s, LED starts blinking red then release the push button.
The LED stops blinking upon successful reset of the device.
The Motion Sensor Dimmer restarts and blinks green for a few seconds.
NOTE:
After reset, the LED turns amber indicating that it is ready for pairing.
3× < 0,5 s
+ 1 > 10 s
×
Using the device
On the
Home
page, tap
All devices
>
Push-button Dimmer
to access the control
panel.
On the control panel page, you can see the following:
•
The current state of the Dimmer (A)
•
Sliding bar to adjust the brightness (B)
•
The current brightness percentage (C)
•
(D)
•
(E)
Push-button Dimmer
On
50%
A
B
C
D
E
Switching/Dimming the device manually
You can turn on/off and increase/decrease the brightness of the dimmer manually.
The dimmer will provide power to the load connected to it.
Short press the push-button (< 0,5 s) once to switch on/off the dimmer.
16
DUG_SmartDim MW Push_ELKO-01
