1
2
3
4
Click!
1
+
-
3
Click!
2
+
-
1. Push a screwdriver into the hole in the upper part of the magnet, the top cover slide
and pull down magnet to open.
2. Break and remove the screw plugs (e.g. with a Screwdriver).
3. Place the base at the desired location (on the window or door frame) and attach it with
suitable bonding material according to the substrate.
4. Insert the top cover of the cover into the hole in the lower cover and snap it into place.
Magnet D/WD
You can attach the magnet in two ways:
• Directly on a fl at surface by gluing * - Apply a suitable adhesive to the outside of the
base. Place the base on the desired location (on the window or door frame) and let it dry.
• Using a suitable fastener ** by screwing.
Replacement of a battery
1. Push the screwdriver into the hole at the bottom of the detector, slide the upper cover
by pulling it up and open the detector.
2. Remove the original battery and insert new batteries into the battery holder. Beware
of the polarity. The LED on the detector will blink.
3. Insert the top cover of the cover into the hole in the lower cover and snap it into place.
Notice:
Only use batteries designed for this product correctly inserted in the device! Immediately replace
weak batteries with new ones. Do not use new and used batteries together. If necessary, clean the
battery and contacts prior to using. Avoid battery shorts! Do not dispose of batteries in water or
fi re. Do not dismantle batteries, do not try to charge them and protect them from extreme heating
- danger of leakage! Upon contact with acid, immediately rinse the aff ected area with a stream of
water and seek medical attention. Keep batteries out of the reach of children. If it is suspected that
the battery has been swallowed or somehow placed inside the body, consult a doctor immediately.
Give the doctor information about the type of battery (from battery case, device or its manual, etc.)
to determine the chemical composition of the battery. Batteries must be recycled or returned to an
appropriate location (e.g. collection container) in accordance with local legal provisions.
When handling a device unboxed it is important to avoid contact with
liquids. Never place the device on the conductive pads or objects, avoid
unnecessary contact with the components of the device.
Safe handling
Recommendations for installation
• For the proper operation of the detector, the correct positioning position must be
maintained so that the sensing distance is maintained when the window or doors are
closed. Therefore, test the position of the detector and the magnetic module before
installation.
• The detector is intended for indoor use.
• Before fixing the detectors in place consult with the manufacturer of the windows and
doors, with regards to the most appropriate way to fix the detector.
• With the appropriate location (at the bottom of the window) can be applied to a win-
dow in a ventilation position.
* The glue must meet the optimal conditions for product placement (infl uence of tem-
perature, humidity ...)
** Suitable fi tting material can be, for example, a countersunk head screw, a screw Ø of
3 mm.
UPLINK
Byte
0-14
15
16
17
18
Bit
7
6
5
4
3
2
1
0
NOTIFICATION
IMEI
Reserved for future use
Tamper:
1 - opened
0 - closed
Accelerometer:
1 - shake
0 - OK
Window sensor 2:
1 - opened
0 - closed
Window sensor 1:
1 - opened
0 - closed
HEARTBEAT
START
Version FW
Subversion
FW
Version FW
Narrowband
Subversion FW
Narrowband
