Elko eLAN-RF-003, Инструкция по эксплуатации

Страница: 11 / 18

29.10.2020 Page
11 of 18
eLAN-RF-003
02-95/2016 / rev.10
Router
The Router function is used to extend the distance and control of RF elements by connecting two
eLANs into the LAN network.
 The first eLAN (so-called Master ) must be set during configuration in the Router function, it
receives all RF commands of controllers via an RF signal. It assess the limitations and
permissions of addresses.
 The second eLAN (so-called Slave ) assess all commands from the eLAN Master
determined for sending by RF signal. It sends valid messages by RF signal to controlled
elements. If a response comes from an element, it sends it to the eLAN
Master .
It is necessary to enter into the settings the LAN parameters of the second eLAN - Slave (IP
address, login data).
The second eLAN Slave can be configured in two ways.
 Active function Repeater – this receives commands via the Ethernet network and
via the RF network.
Example: eLAN Slave catches the RF signal of the RF controller, saves it as
Repeater (signal repeater), and sends the RF signal further along.
 Active function Router – eLAN is in its basic setting. eLAN only receives
commands from the Ethernet network, and ignores all RF signals.

Oasis compatible - the sames as with the Repeater function.

RF Touch compatible - the sames as with the Repeater function.

ist of addresses - the sames as with the Repeater function. The same addresses must be
set for both eLANs.
After setting the function Router , eLAN restarts.

Service button
Here are some sections.
The
eCloud section is used to connect eLAN to a cloud account.
Use the application to create a cloud account.
After clicking on the
eCloud icon, a window will appear where you enter your email address and
password as login details for the cloud account. Then highlight Enable cloud connection and save
with the Save button.
eLAN will connect to your cloud account.