Important: after installation is
completed, turn on hot and cold water
supplies. Check for leaks. Pull the
hose assembly out of the spout and
remove the spray head by unscrewing
it from the hose counterclockwise. Be
sure to hold the end of the hose down
into the sink and turn the faucet on to
the warm position where it mixes hot
and cold water. Flush water lines for
one minute. Check for leaks.
Re-tighten any connections if
necessary, but do not overtighten.
Reinstall spray head by hand
tightening it back onto the spray hose.
Make connections to water lines with 3/8"
female compression supply hoses (1).
If additional hose length is needed, attach
included 1/2" MIP thread adaptors (2) to
supply hoses (1). Use 1/2" I.P.S. faucet
connections (3) or use coupling nuts (5)
with 3/8" O.D.ball-nose riser (4) to make
connections to water lines. Use wrenches
to tighten connections. Do not overtighten.
Screw quick connector to the free end of
pull-down hose. Align male fitting (1) and
tabs (2) on quick connector. Push quick
connector housing firmly upward and
snap onto receiving male fitting. Pull down
moderately to ensure connection has
been made. After connecting the hose,
attach weights (3) to hose at bottom of
loop to prevent hose from twisting and
return hose to proper position.
Retract pull-down hose (1) up through
faucet body, until the pull-down hose
fitting is flush with the bottom of shank
(2). Do not pull hose fitting past the
shank. Insert faucet body through the
hole in sink. From underneath sink,
install plastic washer (3), metal washer
(4) and nut (5) onto the mounting shank.
Do not overtighten.
Note: Do not feed the pull-down hose (1)
back down through the spout until step 3.
Shut off water supplies.
Before installation, remove quick
connector (1) from the free end of
pull-down hose.
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
STEPS:
1
2
1
3
4
5
1
2
3
5
3
4
Ø 1 3/8" ( Ø35mm)
1
2
