(630) 574-8484
Elkay Manufacturing Company
1000005449 (Rev. B - 08/21)
Page 17
5. Startup
1 .
Open the shutoff valves in the filter box and water
supply. Check for any water leaks.
2 .
Place the ON/OFF switch in the upper left-hand corner
of the water dispenser in the OFF position.
3 .
Turn the power to the unit ON (typically a circuit
breaker).
4 .
Remove the scratch-resistant protective layer that is
covering the glass face, the filter cover (if used), and
the back wall of the water dispenser.
Note:
Not removing the back wall covering layer will
activate the IR sensor when the unit is turned ON.
5 .
Move the water dispenser's power switch to the ON
position and make sure the LED lights are lit on the
circuit board.
6 .
Place a container under the water dispenser spout
to activate the fill sensor and dispense at least one
gallon of water to bleed off any trapped air from the
supply lines and filter as well as flush any fine carbon
particles from the filter.
Note:
The water dispenser is set to automatically shut
off after 20 seconds or 16 ounces of water has
been dispensed to prevent overflow and potential
flooding so multiple activations will be required to
get the required one gallon of water flow through
the unit.
7 .
If there are no leaks and the unit is functioning
correctly, install the water dispenser glass cover and
then install the filter box (if applicable) cover using the
flathead screws and a 3/32 inch Allen wrench.
8 .
Upon initial startup, the PLASTIC BOTTLES SAVED
indicator panel should show several bottles have been
saved due to the water used to initially start up the
unit.
9 .
The left-most FILTER LIFE indicator light should also
be lit. This light shows the filter is functioning correctly
and has used less than 65 percent of its capacity.
When the middle blue light illuminates, the filter has
reached 66 percent of its life and will need to be
changed soon. When this indicator light comes on, a
replacement filter should be ordered.
The right-most red light will illuminate in red and
indicates that the filter should be changed.
FILTER LIFE
PLASTIC BOTTLES SAVED
10 .
Once the installation is complete, the water has been
turned on, and any trapped air has been bled from
the system re-check for any water leaks.
11 .
Enjoy fresh filtered water with your new Elkay ezH2O
Liv PRO water dispenser .
