Figure 8
Use, e.g., J-Y(St)Y 2x2x0.8 as bus cable.
o
Connect a measurement point to each connection,
S0 1
or
S0 2
.
Connect measurement point with D0 interface
Figure 9
o
Use RJ10 connector to connect D0 measurement head to socket (4).
o
Set optical communication head on the measurement point optical interface.
o
Relive strain on cable.
i
To prevent manipulation of communication head (e.g. pulling from measurement point) by
unauthorized persons, access to the measurement point should be locked.
5.2 Commissioning
Load the address and the application software
o
Switch on the bus voltage.
o
Assign physical address.
o
Load the application software into the device.
7/9
KNX Metering gateway
82594604
05.02.2016
