Elite Phoenix Gold, Руководство пользователя

Страница: 4 / 8

Elite Amplifier Owner’s Manual
© 2012 Phoenix Gold • www.phoenixgold.com
INPUTS
Connect preamp signal cables from headunit to these inputs. The front,
rear and sub inputs must be used. For example, if only the front input is
used then the rear and subwoofer speaker outputs will have no output
signal.
SUBSONIC CROSSOVER FREQUENCY
Controls the highpass crossover point for the speaker outputs to
eliminate extreme low frequencies.
PHASE
This allows the phase of the subwoofer channel’s output to be adjusted
from 0 to 180 degrees. This adjustment can help achieve better “up front”
subwoofer bass and resolve subwoofer cancellation problems in certain
installations. Each installation is different, slowly adjust and listen for best
results.
REMOTE LEVEL CONTROL
This port is for connecting the subwoofer remote level control. This is not a bass
boost, it controls the level of the subwoofer channel only.
HP OR LP CROSSOVER FREQUENCY
Controls the crossover point for the speaker outputs. See page 8 for exact crossover
settings.
LEVEL
Used to reach maximum amplifier power with a wide variety of headunits.
REAR CONFIG
FLAT: Crossovers are turned off
HP: High pass crossover is on
LP/BP: Low and High Pass crossovers are on, creating a Bandpass (BP) setting for
midbass or midrange speakers.
+12V
This must be connected to the fused positive terminal (+12V) of the car’s
battery. The fuse must be located within 18 inches of the battery.
REMOTE
This must be connected to sw12V, usually a trigger wire coming
from the head unit or ignition.
GROUND
This must be connected to the negative terminal of the car’s battery or
bolted to a clean, unpainted part of the chassis of the vehicle.
RMD
Optional RMD Voltage Display plugs into this port. Sold separately.
CLIP INDICATOR
Lights when the amplifier reaches near maximum output. Under normal
operation the clip indicator should be flashing during the peaks of the
music. The clip indicator should not stay lit for long periods of time (more
than 2 or 3 seconds), if this is the case you need to reduce system volume
or level of the amplifier.
PROTECT INDICATOR
Lights red if there is a problem with the audio system. For example, speaker
wire is pinched/shorted, the amplifier is running too low of an impedance
or reached an unsafe temperature.
SPEAKER OUTPUTS
Used to connect the amplifier to speakers. Front and rear minimum
impedance is 4 ohms bridged or 2 ohms stereo, subwoofer channel is
1 ohm. Use Left + and Right - to bridge the front or rear channels. The
subwoofer speaker terminal is located on the signal side of the amplifier.
ELITE.
5
FUNCTIONS