Elite E-Motion, Инструкция по эксплуатации

Страница: 16 / 60

16
ENGLISH
GB
ASSEMBLY
Your E-MOTION roller does not require any
assembly, since this is done entirely at our
production facility. Each unit is also tested
before being shipped.
USE
Before starting to use your E-MOTION it is
necessary to adjust the centre distance of the
rollers to make them compatible with the size
of your bicycle frame.
Adjustment must be carried out as follows:
1) Measure the length between the centre of
the wheels of the bicycle you are going to use
on the E-MOTION (Fig.1). For the sake of con-
venience this will be called dimension “X”.
2) The distance from the middle point between
the two rear rollers to the centre of the
E-MOTION’s front roller, which for the sake of
convenience will be called dimension “Y”
(Fig.2), must be the same as or as close as
possible to dimension “X” . The axle of the
E-MOTION’s front roller must be positioned in
the hole in the E-MOTION’s frame, whose mea-
surement given on the graduated scale is clo-
sest to dimension “X” (Fig.3). ATTENTION:
Dimension “Y” must be equal to or slightly gre-
ater than “X”. The rollers can be adjusted to
adapt them to bicycles having a distance of
0944-1124 mm (37 to 44 inches).
1
2
3