042717DR
4
Screen Material Installation
Please read this important note before proceeding with the installation process of the material:
Before handling the StarBright CLR® material, put on the supplied pair of white gloves to avoid leaving
fingerprint marks, dust or hand oil on the material’s surface (Figure 1). The StarBright CLR® material is very
delicate and should be handled with extreme care. Do not allow the material to fold or bend.Failure to follow
instructions will result in permanent damage to the screen material, which is not covered by warranty.
1.
Remove the
StarBright CLR®
material from the packaging tube and set it gently on a clean surface.
Tip
: Carefully put a small flat weighted object at the edge (PVC/Velcro end) to prevent it from moving out of place.
Please keep the front of the material face down
.
2.
It is strongly recommended for two people to unroll the material to prevent the screen from bending or rolling
unevenly. Each person holds one end of the roll and slowly unrolls the screen in a clockwise direction (Figure 2).
3.
Lay the material completely flat with the front facing down on a clean surface in a horizontal position (Figure 3).
4.
Carefully and gently place the assembled frame on top of the screen material as shown below. Make sure to not
allow the angle edge of the frame to come in direct contact with the material to avoid puncturing or damaging it.
Screen material back facing up
Velcro
Figure 2
Back side of material
Front side of material
Horizontal position laid on a clean surface
Figure 3
Figure 1
Tip: Small weighted object
