U-00197
3
Frame Assembly
Step 1
: Place the included soft padded EPE sponge sheet on a clean area where the screen will be assembled.
Step 2:
Position the pieces of the frame on the EPE sponge in the arrangement shown below
Step 3:
Insert
center joint (a/b)
connectors into
one-half of the horizontal frame (B/C)
and secure with the
M4x7
screws (M)
as shown in the illustration below.
Tip: The center joint (b) with the larger diameter holes should be on top.
Step 4:
Connect the
elbow joints (c/d)
to the top and bottom sections of the vertical frame. Once inserted, connect
the vertical sections to the horizontal frame sections. Make sure all holes are in alignment and the frame pieces are
flush (no gaps). They should form perfect right angles.
Tip: The elbow joint (d) with the larger diameter holes should be on top.
Step 5
: Secure the elbow joints by fastening them with
M4x7
screws (
g)
, 4 at each
corner.
Screen Material
Step 6:
Put on the
white gloves (p)
and carefully unroll the screen material on a clean surface from the roller to the
other side as shown below. The back side of the screen material should be placed upwards.
Step 7:
Insert the
rods (r)
through the sleeves according to their corresponding lengths on each edge of the screen
as shown below. The short rods (top/bottom) will overlap to secure a firm grasp in the middle areas.
2. Hardware Parts List
a.
b.
c.
d.
e.
f.
g.
h.
i
j.
k.
l.
m.
Back side
Front
Back Side
c.
d.
b.
a.
a.
b.
g.
…
g.
r.
(Black tips)
