V03182021-JA
www.eliteproav.com
5
Note (after all springs have been attached):
Correct material installation
–Corners of the screen material are properly wrapped around the corner edges
of the frame and material is evenly tensioned and flat, creating a nicely taut surface.
Incorrect material installation
–Thecorners of the screen material are not properly wrapped along the edge
of the frame leaving the material with unbalanced tension and an uneven finish. To correct, detach springs
from material at the corner(s) where material does not lie flat along the edge of the frame, reposition the
material so that it lies flat and wraps along the edge of the frame, and reattach springs to the material.
Center Support Bar
Step 11:
Insert the
Center Support Bar (i)
into the upper top groove on the back of the frame with the bottom
end near the approximate center point of the frame and rotate it in at an angle so that both ends of the bar are
in alignment with the groove.
Diagonal Models 150” and below use 1 x Center Support Bar
1
1
1
1
2
3
2
3
To avoid ripples forming in the material it is imperative that all of the corners are properly wrappedaround the
edges as illustrated in the check mark diagrams.
