6/29/17-JA
www.eliteproav.com
6
Center Support Bar
Step 11:
Insert the
Center Support Bar (i)
into the upper top groove on the back of the frame with the bottom
end near the approximate center point of the frame and rotate it in at an angle so that both ends of the bar are in
alignment with the groove.
Diagonal Models 150” and below use 1 x Center Support Bar
Diagonal Models above 150” require 2 x Center Support Bars
Attention: Do not proceed with the Edge Trim installation until making sure there
are no ripples in the material.
Edge Trim Installation
Step 12
: Place the
Edge Trim
over each end of the frame and secure with
M4x6screws (c)
.
Start with the center points first, then the rest of the corners as shown below.
To avoid ripples forming in the material it is imperative that all of the corners are properly wrapped around the
edges as illustrated in the check mark diagrams.