Elite Greenhouses 2'3'' Wide Easy Grow, Инструкции и иллюстрации

Страница: 26 / 32

Fitting the door track support/door track
For the 6’ x 2’ install the door track support onto the upper part of the two middle front bars, for 4’
x 2’ utilise the one middle bar and one of the side corner bars using the bolts inserted into the front
bars previously (page 15 para 3). For the 8’ x 2’ you have a double door track support which fits in
the same way but is twice as long. For the 10’ x 2’ you have two single doors in bays 2 and 4 so
they fit into these bays in the same way as the 6’ x 2’.
This section fits in a similar way to the vent slam bar previously described. It fits onto the bolts that
attach the glazing bars to the gutter. (
Key point ).
N.B. Ensure that the two slotted holes at the end of the door track support are facing upwards, not
downwards. (
Key point ).
Insert 3 bolts into the bolt slot of the door track.
Slacken off the two nuts holding the door track support and push it upwards until it is pressed hard
up against the under side of the gutter lower flange. You must ensure that the door track support
bolts to the upper bolt where the side bars attach to the eave.
Attach the larger hole of the small flat bar (found in fittings) to the bolt channel of the top door
track and let the flat bar hang vertically down. Move the flat bar along the door track until the small
hole on the flat bar lines up with the self tapping screw groove of the roof or side corner bar. Insert
a self tapping screw to secure. This will prevent the top door track from bowing under the weight of
the door.
Insert a bolt into the bolt slot of the door track and line it up with the elongated hole in the angle
bracket.