Elite Greenhouses 2'3'' Wide Easy Grow, Инструкции и иллюстрации

Страница: 23 / 32

3. Sliding the vent into position
The hinge is a groove ‘C’ joint, one ‘C’ is an integral part of the ridge, the other inverted ‘C’
being a part of the vent top rail. (
Key point ).
Firstly identify these two sections and then slide the vent onto the ridge from one end. With
the vent in the open position, push the vent along the ridge until it covers the section where
the vent is to be situated. The two side rails of the vent will overlap the outside edges of the
roof bars. i.e. the vent is wider than the opening it covers.
The vent slam can now be fitted to the two roof bars just underneath the bottom rail of the vent.
The ends of the slam bar are cut out to go round the profile of the roof glazing bar. Secure the slam
bar with the two bolts that were inserted when you fitted the bottom of the roof bars to the eave.
The position of the slam bar is approx. 90mm up from the eave. The space will be fitted with a pane
of glass during glazing later on.
The slam bar is an unequal angle and it attaches to the roof bars with the longer part of the angle
pointing skywards, i.e. toward the bottom rail of the vent, and the shorter part of the angle pointing
to the gutter, i.e. the OUTSIDE corner of the angle is facing INSIDE the structure. (
Key point ).